Unable to program Atmega128
I am using ATMEGA128L on development board. I am trying to program it using an AVR serial ISP with the help of WinAVR. The changes that i made in makefile are as follows. MCU-atmega128 , programmer-avrisp, port-COM1 ( The port which has been assigned by pc ).The development board is getting proper dc power supply as the default program loaded by the vendor in it is running properly.The error that i am getting is "avrdude: stk500_getsync(): not in sync: resp=0x00"The connections between programmer and micro-controller are as follows. connections between programmer and microcontroller programmer -- microcontroller MOSI --- PE0 MISO -- PE1 SCK -- SCK(PB1) RST -- RST of board VCC -- VCC of Dev board GND -- GND of dev board
What are some ideas for an embedded and/or robotics project?
Is it possible to have a single physical USB device appear as two separate device classes?
About Sdram software :Self-refresh mode
What are good tools for using Model Driven Development with Embedded work?
Circular Buffer in Flash
Compiling tesseract-ocr on ARM/Gumstix?
Determine at runtime if Windows CE operating system is built against a particular processor type (eg. ARMV4/ARMV4I/ARMV4T)
Code Banking with SDCC
USB software loopback device on Linux
Embedded app and wearing out flash disks
threadsafe single-consumer, single-producer FIFO on embedded system
Where do you draw the line between what is “embedded” and what is not?
Writing embedded application for msp430?
Prefered method of notifying upper layers about received message
video format with minimal decode time
How to find an embedded platform?